CCIE实验室考试指南(6)
Lab 06 -
Password Recovery Trouble Shooting
Let us assume that you have a router and you don’t know the enable
secret password.
First and foremost you must have physical access to the router to
perform password recovery. Bit 6 defines if the configuration file will
be loaded from NVRAM. Since there is a password in the configuration
file that we do not know, we will want to set bit 6 to 1.
If bit 6 is 0 then the router will load the configuration file from
NVRAM. If bit 6 is 1 then the router will not load the configuration file
from NVRAM.
Configuration Register represented in Decimal
此主题相关图片如下：
The following are the steps to recover from a lost password.
1. Turn the router off, turn the router on, and within 60 seconds
issue the break sequence of your terminal emulation package. If
you are using hyperterminal that would be
2. You will now be in ROM monitor mode indicated by the >
prompt. Our goal here is to turn bit 6 on, so if the configuration
register is set to 0x2102, we want to change the register to
0x2142. To determine the current configuration register setting
use the following command:
>e/s 2000002
To change the register:
>o/r 0x2142
To re-initialize the router
>I
3. After the router prompt appears get into the privileged mode
and copy the backup configuration file to RAM.
4. Get into the configuration mode and key in your new password
|
您将承担一切因您的行为、言论而直接或间接导致的民事或刑事法律责任
留言板管理人员有权保留或删除其管辖留言中的任意内容 本站提醒：不要进行人身攻击。谢谢配合。 |