考试网 >> IT认证 >> 思科 >> Cisco试题 >> CiscoCCNP-BCRAN

发布时间：2006-06-28 03:58     点击：

b. Zip

c. V.32bis

d. Predictor

85. Which dialup networking protocols are supported by Windows 95?

a. RAS

b. PPP

c. Novell NetWare Connect

d. SNA

e. SLIP

86. Which of these points is the boundary for US ISDN circuits?

a. T

b. R

c. U

d. S

87. What is the purpose of DHCP?

a. Resolve the MAC address into an IP address

b. Dynamically boot computers from the network

c. Dynamically assign a MAC address to computers

d. Dynamically assign an IP address to computers

88. What command displays events that are part of NORMAL tunnel establishment or shutdown in VPDN?

89. What command would be used to reset the NAT translations from the translation table?

90. What command is used to configure SPID numbers on a router?

91. Which of the following are types of remote access to network resources?

a. Remote Virtual Connections

b. Remote-Gateway

c. Remote-Control

d. Remote-Node

92. What command will apply a single interface configuration to multiple interfaces?

93. What command is used to set the terminal baud rate on async lines?

94. Which of the following is true of Frame Relay FECN and/or BECN?

a. Logical virtual circuit between Customer Equipment and Frame-Relay network

b. Frame sent from the Frame-Relay network to a router when the network is congested

c. The rate at which a Frame-Relay switch agrees to transfer data

d. Signaling between Customer Equipment and Frame-Relay network responsible for connection management and maintaining status

95. What command string is used to load factory settings on a modem?

a. AT

b. AT&M0

分页:上一页  1 2 3 4 5 6 7 8 9 [10]  下一页  后10页

发表评论： 匿名发表 用户名: 查看评论

您将承担一切因您的行为、言论而直接或间接导致的民事或刑事法律责任 留言板管理人员有权保留或删除其管辖留言中的任意内容 本站提醒：不要进行人身攻击。谢谢配合。